cisco 3020 and 4506 port speed issue

Unanswered Question
Sep 29th, 2010
User Badges:

Hi guys,


   I am trying to setup a trunk connection between C4506 and C3020 Blade switch the problem is that when the 2 sides are in auto negotiation mode they negotiate the speed of 100 even if they are connected to GE port, if i force the 2 sides to speed 1000 the ports remains down.There are no errors shown in interface counters. Anybody has an idea what could cause this.


thnx in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Mahesh Gohil Wed, 09/29/2010 - 03:02
User Badges:
  • Silver, 250 points or more

Hi shen,


I have faced similar problem with cisco switch: 3750 and the solution was to use 4-pair cable rather than using patch-panel

with 2-pair cable.


Please try to chane cable to that of 4-pair if you are using 2-pair cable.


Hope this might be useful to you


Regards

Mahesh

glen.grant Wed, 09/29/2010 - 07:15
User Badges:
  • Purple, 4500 points or more

   Gigabit uses all 4 pairs for gig speed . If you have patches  or any wiring that has less than 8 wires gig is not possible.

Actions

This Discussion