AP Scanner Installation

Unanswered Question
Sep 29th, 2010
User Badges:

We on working on moving from a hotsport architecture to a 95%+ wireless coverage in our campus buildings.  I had wireless survey completed which shows me where i should place my APs to achieve the desired coverage.  We hace a WISM and WCS system and would like to increase our visibility of our wireless network by installation APs in scanner mode.  The question I have is what is the ratio of scanner APs per production AP, or what is the best installation scenario, 1 or two per floor.  I am unable to location any best practices.  We plan on installating AIR-CAP3502is.


Thanks


Mike

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 09/29/2010 - 15:05
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Deploy and activate your APs.  Any excess APs that give out too much signal then convert it to "monitor" mode.

Actions

This Discussion

 

 

Trending Topics - Security & Network