cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
793
Views
0
Helpful
6
Replies

how to track down a rogue ap to the switch

JMCNEL
Level 4
Level 4

What is the easiest way to track down a rogue AP to a switch port so that I can disable it? We have WISM and I we see the rogue  and that its on our wired network. I could not found the macs that was associate with the rogue AP on our switches. I found the AP that reported the rogue AP and I know which switch that AP is connected to but I cannot find the mac.

6 Replies 6

George Stefanick
VIP Alumni
VIP Alumni

If you have WCS the newer version does rouge on switch tracing for you... Have you played with that ?

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

I tried but I get an error stating that it cannot be performed because CDP is not enabled on the controller, even though it is enabled. So I am not sure why this is.

When it says controller, it may mean switch. Is CDP enabled on your switches?

yes we have cdp on all our switches

Are there rogue clients connected to the rogue access point? And, are they generating traffic?

yes on both questions

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: