IOS AP - macro for CLI commands

Unanswered Question
Sep 29th, 2010

Hi all,

I need to remotely shut/no shut the radio interface of an IOS AP setup as a workgroup bridge. Obviously, when ssh'd in and running the following script, my ssh session drops after the shutdown command:

interface dot11radio1

shutdown

no shutdown

So, my question is, is there a way to create a macro and include all three of these commands? That way, I simply run the macro, my ssh session still drops, but the "no shut" command brings the radio back up, allowing me to re-ssh to the AP. It seems like this should be possible.

Thanks for the help in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Elliott Shawd Wed, 09/29/2010 - 13:34

Also, I'm running 12.4(10b)JA3 and I am open to the JDA3 release or other GD releases if they allow for this capability.

Elliott Shawd Wed, 09/29/2010 - 14:32

Are you sure this is for a Cisco IOS Wireless Access Point? I don't know anything about it, but it seems like something more than I was looking for.

Actions

This Discussion

Related Content