09-29-2010 10:33 PM - edited 03-09-2019 11:11 PM
Tell me please, I have two Cams worked in a cluster on version 4.1.8, after updating to version 4.8.0, interfaces, synchronization can not see each other and the tab failover each CAM neighbor is not active (dead)
Sincerely, Alexander
Solved! Go to Solution.
09-30-2010 10:21 AM
Alexander,
Check your certificates. Install the same certificate/private key pair on both CAMs.
More details here:
https://supportforums.cisco.com/docs/DOC-12609
Also other certificate related documents are available here:
https://supportforums.cisco.com/community/netpro/security/others?view=documents
HTH,
Faisal
--
If you find this post helpful, please rate so others can find the answer easily
09-30-2010 10:21 AM
Alexander,
Check your certificates. Install the same certificate/private key pair on both CAMs.
More details here:
https://supportforums.cisco.com/docs/DOC-12609
Also other certificate related documents are available here:
https://supportforums.cisco.com/community/netpro/security/others?view=documents
HTH,
Faisal
--
If you find this post helpful, please rate so others can find the answer easily
10-06-2010 03:18 AM
Faisal,
Thank you very much, it worked for your advice!
09-30-2010 10:55 AM
I could see two possibilities:
a) Certificates issues, as Failsal said
b) Check by using "vi" that the insterfaces that you use for heart beat still the same as 4.1.8
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: