Solved: CAMs does not work in a cluster

a.chernomazov · ‎09-29-2010

Tell me please, I have two Cams worked in a cluster on version 4.1.8, after updating to version 4.8.0, interfaces, synchronization can not see each other and the tab failover each CAM neighbor is not active (dead)

Sincerely, Alexander

Faisal Sehbai · ‎09-30-2010

Alexander,

Check your certificates. Install the same certificate/private key pair on both CAMs.

More details here:

https://supportforums.cisco.com/docs/DOC-12609

Also other certificate related documents are available here:

https://supportforums.cisco.com/community/netpro/security/others?view=documents

HTH,

Faisal

--

If you find this post helpful, please rate so others can find the answer easily

View solution in original post

Faisal Sehbai · ‎09-30-2010

Alexander,

Check your certificates. Install the same certificate/private key pair on both CAMs.

More details here:

https://supportforums.cisco.com/docs/DOC-12609

Also other certificate related documents are available here:

https://supportforums.cisco.com/community/netpro/security/others?view=documents

HTH,

Faisal

--

If you find this post helpful, please rate so others can find the answer easily

a.chernomazov · ‎10-06-2010

Faisal,

Thank you very much, it worked for your advice!

JUAN HUICAB · ‎09-30-2010

I could see two possibilities:

a) Certificates issues, as Failsal said

b) Check by using "vi" that the insterfaces that you use for heart beat still the same as 4.1.8

Juan Huicab Internetworking juan.huicab@nextiraone.com.mx T 52 (81) 1001 8000 E 8015 C 52 (81) 1077 2435 San Pedro Garza García, N. L. México www.nextiraone.com.mx