MGCP-SRST

Unanswered Question
Sep 30th, 2010
User Badges:

Hello,


I am trying to expand the incoming number and add a prefix under srst configuration. I have the translation pattern applied on the pots dialpeer. Call doesnt seem to hit the dialpeer on inbound and hence the translation. Applied the TP on the voice port with same result. The test trasnslation rule shows correct results, adding the prefix. Any ideas ?

Applied translation profile on inbound side of the pots dialpeer.


Thank you,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Thu, 09/30/2010 - 03:31
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

With MGCP, translations and DPs have no effect.

Felipe Garrido Thu, 09/30/2010 - 07:55
User Badges:
  • Cisco Employee,

Are you trying to perform the digit manipulation when the router is registered as an MGCP gateway or when the MGCP endpoint

falls back into SRST mode?


-Felipe

Udit Mehrotra Thu, 09/30/2010 - 20:05
User Badges:
  • Cisco Employee,

Can you paste your Translation Profile and Translation rule config. Also, take following debugs to check which dial-peer is getting matched as inbound dial peer and if translation is taking effect.


debug voip ccapi inout

debug voice translation

Actions

This Discussion