Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
319
Views
0
Helpful
1
Replies

Plug/Unplug V.35 cables on Serial Interfaces with Power

tonyraboza
Level 1
Level 1

‎09-30-2010 07:54 AM - edited ‎03-04-2019 09:57 AM

Hi,

Just  a question - is it safe to plug/unplug V.35 cables (with powered on CSU/DSU on at the end) on serial interfaces (WIC-2T, WIC-1T) when the router is powered-on?  So far, to be safe - what I have been doing is powering down the router when plugging in these cables.  But I am in a situation where I may have to unplug/plug these cables without powering down the router - is it safe to do so?

Thanks in advance.

Best,

Tony

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎09-30-2010 08:06 AM

Yes, it is.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card