H-REAP Vlan Confusion

Unanswered Question
Sep 30th, 2010
User Badges:

Hi,

I'm getting ready to setup one of our remote sites with wireless access of data only, no voice or customer access.  Looks like H-REAP is the solution.  Attached is a diagram of one of our remote site's connectivity and actual vlans.


The following details may be helpful to know:


All LAN vlan routing is static with all vlans advertied out on BGP

Workstations DHCP with a local site server

Phones DHCP with one of the local switches

Currently running a 5500 series WLC at Corporate

Plan to use the 1142n or new 3500 APs

Max 3 APs per site

Remote sites run an ISR and 3560G switches


So, how would I configure routing and switching for the AP's data and control?

Thanks

mlc

Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nicolas Darchis Thu, 10/07/2010 - 22:56
User Badges:
  • Cisco Employee,

Hi Mic,


You need to configure the switchport where APs are conencted as trunk.

The native vlan of the trunk will be the capwap vlan. So pick a "management" vlan where clients don't have access.

Then assign to the AP (from WLC) a vlan for the data SSID. You can pick the same vlan as the workstations.


As simple as that ...

Actions

This Discussion