CiscoWorks Monitoring at High Level

Unanswered Question
Sep 30th, 2010

I have 2 questions.

1) Is Ciscoworks LMS 3.2 able to display status of all the switches under a stack beside seeing the bayface view using Cisco View.

2) From the CM, I am able to create group. However, is it possible to see the network topology view of how each group is connected to each other and if there's an alarm for a switch under the group, you can see perhaps a red colour group icon.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Fri, 10/01/2010 - 21:32

1. Yes, LMS (DFM) can report traps about stack status from the CISCO-STACKWISE-MIB.  RME's detailed device and chassis reports can show the

separate chassis in a stack.

2. No, the groups are not linked in the topology view.  You can view groups as clouds, but there are no interconnections shown.  The events are not perpetuated to the clouds.


This Discussion