How to configure CUCV network connection failover / 2Gbit trunk

Unanswered Question
Oct 1st, 2010

We installed a new Tele Presence Server configuration , CUCM, CTMS , CTS-Manager and a CUVC 52xx.

The CUVC has 2 media blades with on both 2 networks connector(s).

We only connected the upper network connections to the network and would like to have them as a fail-over configuration or if not possible as a single trunk of 2Gbit (2x 1Gbit).

How can i configure the CUVC network ports to act as fail-over so when 1 connection goes down the other gets active. Or how can we configure these 2 ports as a trunk port of 2Gbit.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content