CME Faxing Question - 2901 Router

Answered Question
Oct 4th, 2010
User Badges:

Hello,


We just put in a Cisco 2901 router as our CME/CUE solution with two WIC slots (4 analog ports on each).  This replaced an ICS 7750 solution.


We also have 15 DIDs. I would like to set up one of the DIDs to ring on one of the WIC ports, where a fax machine will be connected to.


Any guidance here would be greatly appreciated.


Thanks,


Phil

Correct Answer by Steven Holl about 6 years 6 months ago

If your provider sends 10 digits, do this:


dial-peer voice 3011 pots

destination-pattern 6471234567

port 0/2/1


Destination-pattern is the string we use to match for an outbound dial-peer match.  You're essentially assigning the DID directly to the phone by doing this.


EDIT: Removed part about CM, since this is a CME install.  Make sure you have direct-inward-dial configured on your inbound dial-peer match for the POTS side.


If you have issues, run:

debug isdn q931

debug voip ccapi inout

debug vpm sig

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Steven Holl Mon, 10/04/2010 - 07:17
User Badges:
  • Cisco Employee,

Be more clear: where are your DIDs coming in?  Is that from a PRI?  SIP trunk?  FXS DID?


I assume when you refer to your 'WIC' ports those are FXS ports.  To get the FXS to ring you simply need a POTS dial-peer pointing to the fax machine port, with a destination-pattern to match the length of the DID that is coming in from the DID circuit.

Phil.Garrelhas Mon, 10/04/2010 - 08:11
User Badges:

Hello,


My aplogies. I'm a bit new to the backend CLI configuration. I've only worked with the front end GUI.


The DIDs are coming in from a PRI. And yes, I mean FXS ports.


I take it the diap peer would look like this:


!Analog fax machine

dial-peer voice 3011 pots

destination-pattern 3011

port 0/2/1


What would the corresponding destination pattern be to match the above? The phone company is sending 10 digits. 6471234567 would be the DID in question.


Also, is there a particular significance to the "3011"? Or, can that number be anything as long as its unused?


Thanks,


Phil..

Correct Answer
Steven Holl Mon, 10/04/2010 - 09:40
User Badges:
  • Cisco Employee,

If your provider sends 10 digits, do this:


dial-peer voice 3011 pots

destination-pattern 6471234567

port 0/2/1


Destination-pattern is the string we use to match for an outbound dial-peer match.  You're essentially assigning the DID directly to the phone by doing this.


EDIT: Removed part about CM, since this is a CME install.  Make sure you have direct-inward-dial configured on your inbound dial-peer match for the POTS side.


If you have issues, run:

debug isdn q931

debug voip ccapi inout

debug vpm sig

Actions

This Discussion