10-17-2010 10:08 PM - edited 03-11-2019 11:55 AM
Hi all,
I have a site to site vpn establish between 2 office using a asa5510 and a pix515. On both firewall i set "management-access inside" which suppose to allow me to use the firewall interface to ping the protected private network of the remote peer. I could do this on my asa5510 but could not do the same on my pix515. Pls advise what other settings is required of my pix. Thks in advance.
Solved! Go to Solution.
10-17-2010 10:14 PM
Are you trying to ping the PIX inside interface, or you are trying to initiate ping from PIX inside interface?
If you are trying to ping the PIX inside interface, pls make sure that you don't have icmp blocks on the inside interface. Check the output of "sh run icmp".
If you are trying to ping from the PIX inside interface, the following command will allow ping: ping inside
10-17-2010 10:14 PM
Are you trying to ping the PIX inside interface, or you are trying to initiate ping from PIX inside interface?
If you are trying to ping the PIX inside interface, pls make sure that you don't have icmp blocks on the inside interface. Check the output of "sh run icmp".
If you are trying to ping from the PIX inside interface, the following command will allow ping: ping inside
10-17-2010 10:19 PM
Hi jen,
Thks, i am trying to ping from the inside interface of the pix firewall. It works.
10-17-2010 10:20 PM
Perfect, thanks..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide