Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
947
Views
0
Helpful
1
Replies

Problem in configuring port-channel between nexus and 3760 switch

lmanavalan
Level 1
Level 1

‎10-22-2010 05:16 AM - edited ‎03-04-2019 10:12 AM

Hi,

i am facing problem in bring up the port-channel between the nexus 7k series swich and cisco 3760 L3 switch.

does this possible at the first place and of possiable what could be the problem that shoping then to come up

Regards

Logesh

Labels:
0 Helpful
1 Reply 1

andrew.prince
Level 10
Level 10

‎10-22-2010 12:06 PM

It could be a protocol mismatch/negotiation error or you have them in a state that will not bring the channel up, or you are not using the correct ports or an incorrect cable/speed/duplex/mdix issue.

Best test is

interface x/x

channel-group # mode on

On both sides, if it comes up cool - if not, then you need to check the cable/ports.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card