cisco aironet 1130g

Answered Question
Nov 14th, 2010
User Badges:

hi


i tried to assign ip address to my access point in Lightweight  mode using command


AP(config)# interface bvi 1


but it doent continue give error "invalid input detected at  "' marker


please help..thank you

Correct Answer by Nicolas Darchis about 6 years 9 months ago

Then you cannot use lightweight access points :-)

I would suggest reconfiguring them as autonomous IOS access points.


Download the IOS software for that AP model and install it on the AP, then it will be configurable like a normal IOS device.


The command is "archive download-sw /f /o tftp:///"


If it doesn't allow  you to type that command try typing "debug lwapp console cli" or "debug capwap console cli" first but you need to be connected via console (no telnet).


Hope this helps !!!


Nicolas


===

Don't forget to rate answers that you find useful

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
Nicolas Darchis Sun, 11/14/2010 - 22:25
User Badges:
  • Cisco Employee,

Hi,


that is because you cannot configure an access point that is lightweight. It has to be configured through the Controller.


Hope this helps,


Nicolas


===

Don't forget to rate answers that you find useful

Dilruwan Rathnayake Sun, 11/14/2010 - 22:33
User Badges:

thanks for reply,


yeah this access point is in lightweight mode  and i dont have a WLAN controller..


i cannot do any thing with this access point even cant go to the web interface.


is their any way to assin ssid or wpa security with cli ,  without going web interface.


thank you

Nicolas Darchis Sun, 11/14/2010 - 22:56
User Badges:
  • Cisco Employee,

Hi,


as mentioned it is configured through the controller. Do you have a WLC ?


I suggest reading http://www.cisco.com/en/US/partner/products/ps6366/products_configuration_example09186a0080665cdf.shtml and http://www.cisco.com/en/US/partner/products/ps6366/products_tech_note09186a00808f8599.shtml


Regards,

Nicolas


===

Don't forget to rate answers that you find useful

Correct Answer
Nicolas Darchis Sun, 11/14/2010 - 23:16
User Badges:
  • Cisco Employee,

Then you cannot use lightweight access points :-)

I would suggest reconfiguring them as autonomous IOS access points.


Download the IOS software for that AP model and install it on the AP, then it will be configurable like a normal IOS device.


The command is "archive download-sw /f /o tftp:///"


If it doesn't allow  you to type that command try typing "debug lwapp console cli" or "debug capwap console cli" first but you need to be connected via console (no telnet).


Hope this helps !!!


Nicolas


===

Don't forget to rate answers that you find useful

Nicolas Darchis Mon, 11/15/2010 - 00:04
User Badges:
  • Cisco Employee,

I suggest you go with 12.4.21. Why do you want to go to 12.3 ?


http://www.cisco.com/cisco/software/release.html?mdfid=279537722&flowid=6775&softwareid=280805680&release=12.4.21a-JY&rellifecycle=ED&relind=AVAILABLE&reltype=latest

(this link had issues to open on google chrome for me but firefox worked like a charm).


Hope this helps,

Nicolas


===

Don't forget to rate answers that you find useful

Actions

This Discussion