×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Syslog alerts and levels setting

Unanswered Question
Nov 22nd, 2010
User Badges:


Hi All,


I have 20 PIX and ASA firewall have been configured in my ciscoworks (lms 2.6)
I am able to get alerts like device down and authentication failure messages through mail, I guess these are from DFM.


My present concerns....


Configure syslogs in firewalls as per level 1-7 (ignore 7-5 in Ciscoworks) is that possible? If I configure syslog level as 1 then it is sending all syslogs from 1-7 which i dont want.
And I need to get syslog alerts from firewals to my ciscoworks and then from ciscoworks to my mailbox through email.


Can someone help me on this.


Thanks in advance.


Regards,
Jopeti.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nael Mohammad Mon, 11/22/2010 - 23:41
User Badges:
  • Silver, 250 points or more

You can use automated actions and syslog filters to achieve this based on the message type.


Resource Manager Essentials > Tools > Syslog > Automated Actions


http://www.cisco.com/en/US/partner/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0/user/guide/syslog.html#wp1211314


RME > Tools > Syslog > Message Filter


http://www.cisco.com/en/US/partner/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0/user/guide/syslog.html#wp1150419

Actions

This Discussion