cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2027
Views
0
Helpful
6
Replies

Router is not boot after rommon reset

aminulnt
Level 1
Level 1

Hi

I just power on 2951 Router and erase default configuration and reload after that router show username I write username Cisco password Cisco router show access deny.I did password break from rommon mode write reset command and show up characters that i cannot read. I can do nothing in this stage. It would be very appreciated if anyone helps to solve this problem.

Thanks

Biplob

6 Replies 6

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Try changing the baud rate to 9600 (default) while you are in Rommon and test again

HTH

Reza

Hi Reza

Thanks for your reply.I did it but it's not working.Any information would be highly appreciated.

Biplob

Biplob,

Usually when you see garbage on the screen, it is baud rate issue.  Try a different one like 38400 and 115200 and test.

Reza

Hi Reza

Thanks for your mail.I am able to get into the router but showing username.I put username cisco and passeord cisco.Can you tell me what should i do.

Cisco Configuration Professional (Cisco CP) is installed on this device.
This feature requires the one-time use of the username "cisco" with the
password "cisco". These default credentials have a privilege level of 15.

YOU MUST USE CISCO CP or the CISCO IOS CLI TO CHANGE THESE  PUBLICLY-KNOWN
CREDENTIALS

Here are the Cisco IOS commands.

username   privilege 15 secret 0
no username cisco

Replace and with the username and password you want
to use.

IF YOU DO NOT CHANGE THE PUBLICLY-KNOWN CREDENTIALS, YOU WILL NOT BE ABLE
TO LOG INTO THE DEVICE AGAIN AFTER YOU HAVE LOGGED OFF.

For more information about Cisco CP please follow the instructions in the
QUICK START GUIDE for your router or go to http://www.cisco.com/go/ciscocp
-----------------------------------------------------------------------


User Access Verification

Username:

Username:
% Username:  timeout expired!
Username: cisco
Password:
% Login invalid

Username:

Thanks

biplob

Ok, login with  username "cisco" and with the password "cisco".

Then go to config mode and create a new user name and password

Example:

username biplob privilege 15 secret 0 password biplob

then

no username cisco

now biplob username is your new one

HTH

Reza

Hi Reza

Thanks .Sorry to late.cisco username and password was not working. After that I broke password from rommon. Now it's working.

Biplob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: