01-19-2011 09:44 PM - edited 03-16-2019 02:58 AM
Hi guys,
I want change something about MeetMe, for example, I host a meeting use MeetMe 5151, then someone dial in the meeting, when we finished, I press "End Call", I hope everyone drop. I know the default setting is if someone forget hung up , the MeetMe resource will keep always. How can I do ? My ccm is 5.0.
Solved! Go to Solution.
01-20-2011 12:38 AM
Hi,
A meet me conference, unlike an ad-hoc conference stays up until there is at least 1 participant in the meet-me conference. The meet-me conference should not drop when one person leaves the conference. It drops only after all the participants have left the conference.
Check the following doc for conferences
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml
HTH
Regards
Nitesh
PS:Pl rate helpful posts
01-20-2011 12:38 AM
Hi,
A meet me conference, unlike an ad-hoc conference stays up until there is at least 1 participant in the meet-me conference. The meet-me conference should not drop when one person leaves the conference. It drops only after all the participants have left the conference.
Check the following doc for conferences
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008009476a.shtml
HTH
Regards
Nitesh
PS:Pl rate helpful posts
01-20-2011 01:24 AM
Hi,
Thanks for your reply, I hope you are right. I have to give up testing .
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: