Solved: Username

scooter817 · ‎02-03-2011

Hi

I wanted to know if i can have someone help me with what command to use.

I've loaded up GNS3 on my desktop and i'm going through my Cisco IOS in a

nutshell book and i'm pick out commands to use to understand how to make a

config from scratch.Everything looks fine when i do sh run, but when i exit all the

way out and it comes back up to my Security banner it's asking for a username

and i don't remember putting in a username. So if you can tell me what command

i'm missing i can just start back over and make a new config.Thanks in advance and

have a great evening.

Mohamad Qayoom · ‎02-05-2011

Try cisco as your password.

Sent from Cisco Technical Support iPhone App

View solution in original post

zoltanszasz · ‎04-10-2011

In the GNS3 main window you can right click the router and go to Config file section, there you replace or delete username related section. Then you restart the router and set up new user from console.

View solution in original post

Javi Benito · ‎02-03-2011

Hi,

Try with this:

http://www.cisco.com/en/US/products/hw/routers/ps221/products_password_recovery09186a0080094773.shtml

Regards,

Javi

shalin111 · ‎04-18-2011

Thanks for kicking off the replies, appreciate the help !

Shalin Singh

http://holytraffic.com
http://4xindia.com

cadet alain · ‎02-04-2011

Hi,

On GNS3 you can access the config so just post it here and we will tell you what's wrong or not.

Regards.

Alain.

Don't forget to rate helpful posts.

Mohamad Qayoom · ‎02-05-2011

Try cisco as your password.

Sent from Cisco Technical Support iPhone App

zoltanszasz · ‎04-10-2011

In the GNS3 main window you can right click the router and go to Config file section, there you replace or delete username related section. Then you restart the router and set up new user from console.

Report Inappropriate Content · ‎04-13-2011

Javi is correct, follow the instructions on the link he posted. This is a procedure you should become familiar with anyway.

You most likley issued the "aaa new-model" command and didnt set up a local user database and didnt set the authentication parameters.