02-04-2011 09:28 AM - last edited on 11-29-2022 08:20 PM by Translator
I had used the interface serial 0/0/0 with
NO FAIR-QUEUE
command but now it doesn't seems that I could get it out. Even after I erase startup-config and do reload. Someone told me if I just put
FAIR-QUEUE
eventually this command will go away after you erase the startup-config & reload but I proved it wrong, that
NO FAIR-QUEUE
is still in my interface serial. If anyones could help me to take this thing out of my serial interface I would really appreciated.
R1#sh run | b interface
interface Loopback1
description Engineering Department
ip address 10.1.1.1 255.255.255.0
ip ospf network point-to-point
!
interface FastEthernet0/0
ip address 10.1.200.1 255.255.255.0
ip ospf cost 50
ip ospf priority 10
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0/0
bandwidth 64
ip address 10.1.100.1 255.255.255.0
no fair-queue <====================== Here it is
clock rate 64000
Thx in advance for your help!
Solved! Go to Solution.
02-04-2011 09:34 AM - last edited on 11-29-2022 08:35 PM by Translator
02-04-2011 09:34 AM - last edited on 11-29-2022 08:35 PM by Translator
Try going into the interface and put default
fair-queue
02-04-2011 10:02 AM
Thank you NetworkNinja79 - I never think of that, now it went away for good until I use it again for my next lab.
Cheerio....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: