02-10-2011 01:34 PM - edited 03-06-2019 03:29 PM
I'm getting the following error when I try to configure
my uplinks on my 5K back to my 7K's.
command failed: port not compatible [DCE mode]
I'm currently running NX-OS: n5000-uk9.5.0.2.N1.1.bin
Any ideas would be helpful.
interface port-channel10
switchport mode trunk
vpc 10
switchport access vlan 5
switchport trunk native vlan 2005
switchport trunk allowed vlan 5,7
speed 10000
interface Ethernet1/33
switchport mode trunk
switchport access vlan 5
switchport trunk native vlan 2005
switchport trunk allowed vlan 5,7
spanning-tree port type network
udld aggressive
channel-group 10 mode passive
command failed: port not compatible [DCE mode]
Solved! Go to Solution.
02-10-2011 11:25 PM
There is a bug for this issue which is fixed in 5.0(2)N2(1) which is on CCO. Here is the bug details
CSCtk04010 Port errors when adding to port-channel port not compatible [DCE mode]
Symptom:
Cannot add port to port channel.
Error:
command failed: port not compatible [DCE mode]
Conditions:
adding ports to port channel
Workaround:
remove and re-add the port channel config
Upgrading or re-adding the config should work
Kind regards,
Maarten Vervoorn
02-10-2011 11:25 PM
There is a bug for this issue which is fixed in 5.0(2)N2(1) which is on CCO. Here is the bug details
CSCtk04010 Port errors when adding to port-channel port not compatible [DCE mode]
Symptom:
Cannot add port to port channel.
Error:
command failed: port not compatible [DCE mode]
Conditions:
adding ports to port channel
Workaround:
remove and re-add the port channel config
Upgrading or re-adding the config should work
Kind regards,
Maarten Vervoorn
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: