Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
7754
Views
5
Helpful
1
Replies

NAT using an SG 300-10

daanmaijer
Level 1
Level 1

‎02-14-2011 10:57 PM

Hi. I've just received an SG 300 and am in the process of tuning the configuration. We have a couple of compute servers that have been behind a PIX 515e that we would like to move over to the SG 300. Is there a way to enable / configure the SG 300 to perform NAT? i.e. 192.168.1.10 gets translated to 1.1.1.10

Thank you in advance.

Regards,

Daan

1 person had this problem
Labels:
0 Helpful
1 Reply 1

David Hornstein
Level 7
Level 7

‎02-21-2011 05:43 AM

Hi Daan,

The 300 series can switch at layer 3 between vlans, but cannot be setup as a NAT.  You still have to rely on a router for that.

regards Dave

Customers Also Viewed These Support Documents