[ITP7613] Can i disable this notice ?

Texas Hare · ‎02-20-2011

Hi all.

I have been using the Cisco 7613 for ITP Sigtran service.

And I had upgrade IXH1 to IRE version.(Cisco IOS Software, s72033_rp Software (s72033_rp-ITPK9V-M), Version 12.2(33)IRE2, RELEASE SOFTWARE (fc2))

but i have seen this message at "wr" command below.

Co1#wr
Building configuration...
[OK]
%NOTICE: unsaved cs7 data exists for MTP3 Route.
Use exec command cs7 save <xxx> to save listed applications.

I know that this message is noticed for save MTP3 routing table to another location.

So, I attempted to save MTP3 routing table by using cs7 save <storage location> <file name> command.

As a result, I couldn't see that message anymore.

But I really want to know , whether Saving MTP3 routing or did not i don't wanna see this message anymore.

If you have any other way this "%NOTICE: unsaved cs7 data exists for MTP3 Route." message. what should i do?

anikas · ‎11-28-2011

Sangrae,

It looks like you are running into the following defect.

CSCtg35799 Bogus notice to save MTP3 routing update on write mem or reload

This is a bogus notice. The 'write mem' completes and the routing change is saved to startup-config.

This being said upgrading is the only way to resove this issue.

I hope this helps.