Hi all,

i've problem, switch "authorization failed" on every command that i type.

Switch#sho run
Command authorization failed.

Switch#conf t
Command authorization failed.

i only use basic configuration. *attached below

Switch config :

aaa new-model
!
aaa authentication login default group tacacs+ none
aaa authentication enable default group tacacs+ none
aaa authorization config-commands
aaa authorization exec default group tacacs+ if-authenticated
aaa authorization commands 1 default group tacacs+ if-authenticated none
aaa authorization commands 15 default group tacacs+ if-authenticated none
!
aaa session-id common

!

ip tacacs source-interface Vlan888
tacacs-server host 10.255.253.25
tacacs-server key cisco

!

ACS config :

# Network resources - network devices and AAA clients

     * name switch , ip 10.255.253.65 , authen option : tacacs+ , shared secret cisco

# User and identity store - internal identity store - users

     * name tester , pass : passw0rd , enable pass : enable

# Policy elements - authorization and permissions - device administration - shell profile

     * name : testProfile , command task - maximum privilege 15 , (default privilege not in use / default)

# Policy elements - authorization and permissions - device administration - command sets

     * name : PermitAll , mark "Permit any command that is not in the table below"

# Access policies - access service - default device admin - authorization
     * rule-8 , identity group in all groups , shell profile : testProfile

has anyone seen this type of issue and perhaps offer some advice on what I am missing.

Many Thanks in advanced.