Will a reset on a 1242 to factory defaults...

Answered Question
Jun 2nd, 2011

I have a 1242 that was configured for LWAPP and I reset to factory defaults. I'm curious if it returned to autonomous mode?

Thanks in advance

I have this problem too.
0 votes
Correct Answer by Stephen Rodriguez about 3 years 9 months ago

It should not have.  When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.

So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.

Cheers,
Steve

--

If  this helps you and/or answers  your question please mark the question as "answered" and/or rate it, so  other users can easily find it.

  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 5 (1 ratings)
Correct Answer
Stephen Rodriguez Thu, 06/02/2011 - 12:54

It should not have.  When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.

So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.

Cheers,
Steve

--

If  this helps you and/or answers  your question please mark the question as "answered" and/or rate it, so  other users can easily find it.

Actions

Login or Register to take actions

This Discussion

Posted June 2, 2011 at 12:47 PM
Stats:
Replies:1 Avg. Rating:5
Views:889 Votes:0
Shares:0
Tags: No tags.
 

Discussions Leaderboard