06-02-2011 12:47 PM - edited 07-03-2021 08:16 PM
I have a 1242 that was configured for LWAPP and I reset to factory defaults. I'm curious if it returned to autonomous mode?
Thanks in advance
Solved! Go to Solution.
06-02-2011 12:54 PM
It should not have. When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.
So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.
Cheers,
Steve
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
06-02-2011 12:54 PM
It should not have. When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.
So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.
Cheers,
Steve
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: