cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1076
Views
0
Helpful
7
Replies

ASA 5520 with NAT and HTTP traffic

shasun
Level 1
Level 1

Hi Friends,

Shall i configure like this,

1. Static NAT to ISP1

    HTTP traffic to ISP2

2.if ISP1 fails ALL Static NAT and HTTP traffic should go through ISP2

pls guid me

1 Accepted Solution

Accepted Solutions

Hi Thiru,

Yes, if you configure it as per the doc, whenever ISP1 fails, all the traffic including http, would go through your ISP2 only.

Varun

Thanks,
Varun Rao

View solution in original post

7 Replies 7

varrao
Level 10
Level 10

Yes that is correct, it would failover to the ISP2

Thanks,

Varun

Thanks,
Varun Rao

Hi Varun,

Is this possible in ASA 5520?

Yes, it is definitely.

Thanks,

Varun

Thanks,
Varun Rao

tasneemjan
Level 1
Level 1

Hi,

You might want to look at static route tracking with sla monitor. You can use icmp to ping an ip address to ISP1 and if ASA sees a drop in ping reply it would populate a backup route in the routing table.

Regards

Hi,

yes, that's correct,

Shall i configure ISP1 to take the Static NAT traffic, at the same time ISP2 take the HTTP traffic for user web browsing. Same time both ISP Will work? Suppsoe ISP2 goes down only internet browsing Stopped, that is not an issues,

if ISP1 fails, ISP2 will takecare of both traffic? is this possible in ASA5520 or we will go to router?

pls clarify me, i'm so confused

Hi Thiru,

Yes, if you configure it as per the doc, whenever ISP1 fails, all the traffic including http, would go through your ISP2 only.

Varun

Thanks,
Varun Rao

Hi,

So it require router to fulfill our requirements for configure loadbalance and failover.

Thanks for valued support,

thiru

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: