07-23-2011 02:48 AM - edited 03-16-2019 06:05 AM
Hi
I`ve trying to reduce my dial-peers by using Trunk groups using the following http://www.markholloway.com/blog/?p=452
I`ve added a trunk group PSTN-OUTBOUND
hunt-scheme sequential both up
Added it to the Serial Interface as below
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-qsig
isdn incoming-voice voice
trunk-group PSTN-OUTBOUND
no cdp enable
!
Tried to add the trunk grp to the Dial-peer but got the following error
GLBSSRSTVG01(config-dial-peer)#trunkgroup PSTN-OUTBOUND
ERROR: voice port exists
GLBSSRSTVG01(config-dial-peer)#
Then tried to add it to voice-port but got this
(config-voiceport)#trunk-group PSTN-OUTBOUND
Error: Failed to add non-analog port to trunk group
Configure in cas-custom mode or serial interface
mode for T1/E1 digital ports and in BRI interface
mode for BRI voice ports
My thinking is that I create a Trunk group called PSTN and then assign it to the Serials and then assign it to Dial-Peers- is this correct?
any help
Thanks
07-23-2011 05:29 AM
from the link you put its applied to the serial interface of each PRI then to the POTS dial peers
by the way if you use dial peers with same perefrence using diffrent PRIs the GW will loadbalncie the calls on these PRIs as well
07-23-2011 09:28 AM
Hi Ipt,
It sounds like you already have the port commands configured on your dial-peer (port 0/3/0:23 for example). You'll need to remove the port command in order to add the trunkgroup PSTN-OUTBOUND to your dial-peer which is why you're receiving the voice port exists error.
HTH,
Chris
Please rate helpful posts
06-27-2018 06:44 AM
Good post. Solved my problem with IOS 15.1 on 2911 .
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: