Span to PC Port - Cisco 7941

Answered Question
Jul 27th, 2011

Hi, I'd like to enable 'Span to PC Port' on a cisco 7941 - [Settings - Device Configuration - Ethernet Configuration - Span to PC Port] so we can have a look at the traffic with an analyser and ensure the TOS value is correct.

We are using v7.1.3 CUCM

Phone load file SCCP41.8-5-3S

How do you go about this?

Thanks in advance,


I have this problem too.
0 votes
Correct Answer by clileikis about 4 years 2 months ago

Hi Brendan,

Check out the following post:

The following settings can be found in CUCM by going to Device > Phone and selecting the appropriate phone: 

PC Port  set to enabled

PC Voice VLAN Access set to enabled

Span to PC Port set to enabled



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (2 ratings)


This Discussion