Save configuration in ASA 5505

Answered Question
Oct 24th, 2011

Hi all,  I have this issue, I save the configuration in the ASA 5505 using write memory or using copy run start but whe i unplug the power cord and plug it back in the ASA gets its factory default configuration.... then what i do is a copy start run to get the configuration active....

why is this so? even though i saved the config to flash ... regards!

I have this problem too.
0 votes
Correct Answer by Eugene Khabarov about 3 years 5 months ago

You have incorrect boot register:

Please follow up the following document:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1062992

You need to set up default value 0x1

___

HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Correct Answer
Eugene Khabarov Fri, 10/28/2011 - 01:49

You have incorrect boot register:

Please follow up the following document:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1062992

You need to set up default value 0x1

___

HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"

adavila03 Fri, 10/28/2011 - 07:07

I never changed the config register. the default value was 0x41 . I switched it back to 0x1.

Thanks for your response! 

Actions

Login or Register to take actions

This Discussion

Posted October 24, 2011 at 9:10 AM
Stats:
Replies:2 Overall Rating:5
Views:2819 Votes:0
Shares:0
Tags: No tags.
 

Discussions Leaderboard

Rank Username Points
1
tsteger1
916
2
acomiskey
894
3
Patrick Iseli
850
4
jmia@ohgroup.co.uk
808
5
jackko
787
Rank Username Points
Marvin Rhoads
14
Collin Clark
10
Karsten Iwen
10
Neno Spasov
10
dhananjoychowdhury
5