I am trying to limit traffic inbound to 10Mbps on a gig interface 0/48 set to 100/full. So I downloaded some big
files over this link and I'm able to see 30-40Mbps or more. You can see from the show int - rate-limit command that parameters
are never showing exceented so nothing has been dropped. What am I missing? Thanks.
interface GigabitEthernet0/48
description ATT Link 100Mbps
no switchport
ip address 10.10.7.2 255.255.255.252
rate-limit input 10000000 10000 10000 conform-action continue exceed-action drop
speed 100
duplex full
c3560-1#sho int gi 0/48 rate-limit
GigabitEthernet0/48 ATT Link 100Mbps
Input
matches: all traffic
params: 10000000 bps, 10000 limit, 10000 extended limit
conformed 0 packets, 0 bytes; action: continue
exceeded 0 packets, 0 bytes; action: drop
last packet: 2167248835ms ago, current burst: 0 bytes
last cleared 00:04:41 ago, conformed 0 bps, exceeded 0 bps
mccx-c3560-1#show int gig 0/48
GigabitEthernet0/48 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 30e4.db3c.08c5 (bia 30e4.db3c.08c5)
Description: ATT Link to Herakles 100Mbps
Internet address is 10.10.7.2/30
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 31/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 12487000 bits/sec, 1110 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12137264 packets input, 3932863552 bytes, 0 no buffer
Received 18 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
