Cpam- Door State Inconsistent

philtraylor · ‎11-03-2011

Anyone know why on earth I would get this error?

I have a couple doors showing alarms for "Door State Inconsistent"

I can not seem to figure out why. All the devices associated to the door are functioning properly...

Thanks!

Phil

mcwalter · ‎11-04-2011

Which input triggering the door state inconsistent event?

philtraylor · ‎11-04-2011

I can not tell. Further examination of the alarm does not seem to specify which input point is causing the issue.

What am I missing?

mcwalter · ‎11-04-2011

You may want to run a system sanity report. It may tell you where the error is. Good luck.

philtraylor · ‎11-04-2011

Good call. I will check there. Thank you!

Finbarr Rogers · ‎08-02-2012

Hi,

I have the same issue at the minute. Have you had any further help on this?

Kind regards,

Finbarr

philtraylor · ‎08-02-2012

I have not gotten much luck in this area, I ended up disabling this alarm entirely.

wsmith3212 · ‎08-29-2012

Generally I have found that a motion REX that is incorrectly configured to trip the lock in a high traffic area can pop the lock when the door isnt being used causing that alarm.