Cpam- Door State Inconsistent

Unanswered Question
Nov 3rd, 2011

Anyone know why on earth I would get this error?

I have a couple doors showing alarms for  "Door State Inconsistent"

I can not seem to figure out why. All the devices associated to the door are functioning properly...

Thanks!

Phil

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
mcwalter Fri, 11/04/2011 - 11:36

Which input triggering the door state inconsistent event?

philtraylor Fri, 11/04/2011 - 11:38

I can not tell. Further examination of the alarm does not seem to specify which input point is causing the issue.

What am I missing?

mcwalter Fri, 11/04/2011 - 11:58

You may want to run a system sanity report. It may tell you where the error is. Good luck.

finbarrrogers Thu, 08/02/2012 - 03:46

Hi,

I have the same issue at the minute. Have you had any further help on this?

Kind regards,

Finbarr

philtraylor Thu, 08/02/2012 - 06:06

I have not gotten much luck in this area, I ended up disabling this alarm entirely.

wsmith3212 Wed, 08/29/2012 - 17:56

Generally I have found that a motion REX that is incorrectly configured to trip the lock in a high traffic area can pop the lock when the door isnt being used causing that alarm.

Actions

Login or Register to take actions

This Discussion

Posted November 3, 2011 at 2:02 PM
Stats:
Replies:7 Avg. Rating:
Views:1410 Votes:0
Shares:0
Tags: No tags.

Discussions Leaderboard

Rank Username Points
1 97
2 66
3 64
4 45
5 44
Rank Username Points
5
4
3