Trunk between Cisco 3560 and Juniper ex4200

Unanswered Question
Nov 9th, 2011
User Badges:

I need to create a trunk between a Cisco 3560 and a Juniper EX4200


I am perfectly happy with the the Cisco side and want to only allow 1 vlan across the trunk, which I was going to configure on the 3560 side.


Has anyone any experience on trunking to a Juniper Ex4200


Looking at the Juniper side it looks like I just set the port as a L2 uplink.


Thanks


Roger

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Reza Sharifi Wed, 11/09/2011 - 07:03
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

You can allow certain vlan(s) on the trunk by using the memeber command:


here is the command:


[email protected]> show configuration

interfaces {

ge-0/0/13 {

unit 0 {

family ethernet-switching {

port-mode trunk;

vlan {

members [10 20 30 40];


HTH

Giuseppe Larosa Wed, 11/09/2011 - 08:57
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Roger,


EX-4200 are multi layer switches. The most important difference is that Vlans/broadcast domains have names and need to be associated to an 802.1Q Vlan-id.


the following commands can be of help


ex-4200> configure

ex-4200# set vlans INTER-SWITCH vlan-id 100


ex-4200# set interface ge-0/0/0 unit 0 family ethernet-switching port-mode trunk

ex-4200# set interface ge-0/0/0 unit 0 family ethernet-switching vlan members INTER-SWITCH


ex-4200#commit

ex-4200#exit




the default is that no vlans are allowed on the trunk on the EX-4200. multilple Vlans can be permitted by using the last command that refers to the vlan object name and not the to the 802.1Q vlan-id


commit is required to apply the change in junos


Hope to help

Giuseppe

Actions

This Discussion