DCNM-SAN Permission Denied

Unanswered Question
Nov 9th, 2011

I have a MDS 9148 that I have been trying to configure, so I blew away the configuration and ran setup again. It looked normal, I could access it from putty but when I try to use DCNM-SAN to configure it I get "Permission Denied" on everything, new zoneset, new zone, etc. What am I missing?

I have this problem too.
1 vote
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
Trevor.RobertsJr Mon, 03/11/2013 - 18:10

On the MDS, check your DCNM snmp user's group permissions using the show snmp user command.

If it is anything other than network-admin, run the following command to give your DCNM user admin access:

snmp user YourUsername network-admin

If you continue to have access problems, try removing the non-admin user groups from your user's authority list:

no snmp user YourUsername network-operator

Make sure that your DCNM snmp user has a strong password!!!

======================================================================================

If my answers have been helpful in any way, please rate accordingly.  Check out my blog for useful vSphere & UCS tips: www.vmtrooper.com

Actions

Login or Register to take actions

This Discussion

Posted November 9, 2011 at 6:09 AM
Stats:
Replies:1 Avg. Rating:
Views:962 Votes:1
Shares:0

Related Content

Discussions Leaderboard

Rank Username Points
1 297
2 134
3 133
4 132
5 80
Rank Username Points
10
5
4