×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Auto Configuration file population

Unanswered Question
Nov 11th, 2011
User Badges:

Hi Folks,


I'm looking for the most effiencient and reliable way to load configuration onto 250 2911's. Here's the criteria; The devices will be set up in our lab and that is were the configuration will be carried out. they will all be using the same subnet. Obviously every configuration file will be different but large parts will be identical for every single device.


Is there a way to use dhcp to populate the IP addresses of the 2911's and then have some kind of process where a test switch or router pushes a configuration file to each node in that subnet?


It would be even better if we could push prepared indivdual config files to corresponding IP addresses but we can get a generic config file done I'd be happy


Regards


Ciaran

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion