×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IP addresses taken and not released (SPR527W)

Unanswered Question
Nov 21st, 2011
User Badges:

Hello,


I have  the SRP527W model.


The situation is the devices are taking the IP address from the DHCP pool and I am running out.


The setting for the client lease time is 0 = 0 means one day

I could change it to 5 = 5 mins at start up


How do i change the settings so other devices that are not on the network anymore give back the Ip addresses to the pool and not keep them forever.  I am running out of IP address in the DHCP pool and have so far have a max of 120 users.


I would also like to note I ve not set any of these addresses as static to the client.  If they are not on the network after a week, the ip address should go back to the pool, whats going on?


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion