×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CUCM equivalent to CME silent button commandHi

Answered Question
Nov 23rd, 2011
User Badges:
  • Blue, 1500 points or more

Hi, I have a customer moving from CME to CUCM 8.5.


In the CME config they use the button1s1 command which enables the silent ring feature for the line. Lines on other buttons will still ring.


Is there any way to mimic this on CUCM?


CUCM DND turns off the ringer for all lines on the device.

Correct Answer by Rob Huffman about 5 years 9 months ago

Hi James,


Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only

on Line 1 under the DN config page itself. This would have no effect on the other

lines on the phone


Cheers!

Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Wed, 11/23/2011 - 09:24
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi James,


Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only

on Line 1 under the DN config page itself. This would have no effect on the other

lines on the phone


Cheers!

Rob

Rob Huffman Wed, 11/23/2011 - 09:44
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hey James,


Thanks for your kind words buddy, but I've put up so many terrible answers here

that I should have probably been banned from CSC at this point Hahahaha!


Here's one from yesterday...yikes!! What was I thinking??


https://supportforums.cisco.com/thread/2117495?tstart=30


Glad to be of some small help here.


Cheers!

Rob

Actions

This Discussion