11-23-2011 09:16 AM - edited 03-16-2019 08:12 AM
Hi, I have a customer moving from CME to CUCM 8.5.
In the CME config they use the button1s1 command which enables the silent ring feature for the line. Lines on other buttons will still ring.
Is there any way to mimic this on CUCM?
CUCM DND turns off the ringer for all lines on the device.
Solved! Go to Solution.
11-23-2011 09:24 AM
Hi James,
Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only
on Line 1 under the DN config page itself. This would have no effect on the other
lines on the phone
Cheers!
Rob
11-23-2011 09:24 AM
Hi James,
Well you can the Ring Setting - Phone Idle & Phone Active to Flash Only
on Line 1 under the DN config page itself. This would have no effect on the other
lines on the phone
Cheers!
Rob
11-23-2011 09:36 AM
Rob you are a superstar
11-23-2011 09:44 AM
Hey James,
Thanks for your kind words buddy, but I've put up so many terrible answers here
that I should have probably been banned from CSC at this point Hahahaha!
Here's one from yesterday...yikes!! What was I thinking??
https://supportforums.cisco.com/thread/2117495?tstart=30
Glad to be of some small help here.
Cheers!
Rob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide