×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Outgoing Call Routing

Unanswered Question
Nov 28th, 2011
User Badges:

Hi team,


I have a UC560 with 12 FXO lines. How can I route outgoing calls based on the source.

     eg:

          - extension 100 to 105 should always go via FXO port 1

          - extension 106 to 110 should always go via FXO port 2


Nuwan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
acampbell Mon, 11/28/2011 - 04:14
User Badges:
  • Green, 3000 points or more

Hi,


I have had a search for configuring CoR via CCA but I can not find very much

I dont use CCA in my day job so if it was me I would need

to use cli.


I am including another link which gives a good explanation of CoR.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml


You could also try asking your CCA question under the "small business forum" where I am sure

you will obtain further help.


https://supportforums.cisco.com/community/netpro/small-business


HTH

Alex


Please rate useful posts

Actions

This Discussion

Related Content