11-28-2011 03:11 AM - edited 03-16-2019 08:15 AM
Hi team,
I have a UC560 with 12 FXO lines. How can I route outgoing calls based on the source.
eg:
- extension 100 to 105 should always go via FXO port 1
- extension 106 to 110 should always go via FXO port 2
Nuwan
11-28-2011 03:18 AM
Hi,
You will need to configure Class Of Restriction
COR
Hth
Alex
11-28-2011 03:55 AM
Hi Alex,
Thanks for your response. Can I do this using CCA 3.1?
Nuwan
11-28-2011 04:14 AM
Hi,
I have had a search for configuring CoR via CCA but I can not find very much
I dont use CCA in my day job so if it was me I would need
to use cli.
I am including another link which gives a good explanation of CoR.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml
You could also try asking your CCA question under the "small business forum" where I am sure
you will obtain further help.
https://supportforums.cisco.com/community/netpro/small-business
HTH
Alex
Please rate useful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: