×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Trace incoming call on SIP trunk

Unanswered Question
Dec 13th, 2011
User Badges:

I am integrating Avaya S8300 with CUCM 8.6. I have created SIP trunk and route pattern on both sides. When i calling from Avaya to CUCM its showing call going on CUCM SIP trunk but call dropped after some time. I want to trace on CUCM side on SIP trunk. Can anyone know to achieve this?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Volodymyr Morskyy Tue, 12/13/2011 - 05:21
User Badges:
  • Bronze, 100 points or more

You can enable loggin on the cucm. Or in case you are using cisco switch to connect one of the devices, you can configure monitor session and sniff the signaling to see who is dropping the connection.


HTH

Volodymyr Morskyy Wed, 12/14/2011 - 00:55
User Badges:
  • Bronze, 100 points or more

Go to serviceability page, trace, select server, then CCM service, enable SIP stack trace. Then from CLI check the logs after faulty call


file tail activelog /cm/trace/ccm/sdi recent

Actions

This Discussion