×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco CME w/Exchange 2010 UM - Faxing

Unanswered Question
Dec 13th, 2011
User Badges:

Has anyone setu faxing between CME and Exchange 2010? We have voicemail working perfectly yet I have not been able to locate any documentation/examples on setting up faxing.  My own attempts have proven unsuccesful as well.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

I too would like to know if this is possible and how to do it.  I look every so often to see if anybody has posted anything, but haven't found anything to date.


Marcus, have you been able to figure it out since you posted this?


Anybody who is a Cisco wizard care to chime in on this?  I'm admittedly new to Cisco hardware and am in the same boat as Marcus here.

Marcus Olson Fri, 06/22/2012 - 00:58
User Badges:

I found out that with Exchange 2010 you need a fax gateway, so I purchased some software.. however I haven't yet been able to figure out how to get the fax gatewawy software and the cisco CME router to properly communicate... so in short.  Nope, haven't figured it out.   I'll admit I haven't invested a whole lot of time into figuring it out.

Actions

This Discussion