Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
799
Views
0
Helpful
2
Replies

CallConnector Operator - How to Configure with CC Server

invtechnologies
Level 1
Level 1

‎12-19-2011 07:24 AM - edited ‎03-21-2019 05:05 AM

I have a Smart CallConnector server setup and fuctional.  The Advanced Client works fine.

Want to setup the Operator Console but the only install that I have found is the Stand-Alone version.  Is this the version that I should use?  It is installed on a PC, but I cannot figure out how to set it up to use the server.

Thanks!

Labels:
0 Helpful
2 Replies 2

Jeremy Koch
Level 1
Level 1

‎12-19-2011 01:24 PM

yes champ, you need the client version. Uninstall the standalone version and get the client version and install

UC540 system with 8.6.2 Software Pack
0 Helpful

invtechnologies
Level 1
Level 1
In response to Jeremy Koch

‎12-19-2011 01:48 PM

Is there another place to get the software?  The download site connected to the community only lists the Stand Alone version and we did not purchase support with the software.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents