MIB for remote query DOCSIS 3.0

Miroslav Habanik · ‎12-22-2011

Hi,

I use uBR7225VXR, UBR-MC88V card, IOS:ubr7200p-jk9su2-mz.122-33.SCD6.bin

I configured remote query future on CMTS. It works perfectly I can see all parametres that I need:

#sh cable modem e448.c7dd.f2c5 phy

MAC Address I/F Sid USPwr USMER Timing DSPwr DSMER Mode DOCSIS

(dBmV) (SNR) Offset (dBmV) (SNR) Prov

(dB) (dB)

e448.c7dd.f2c5 C1/0/U0 1 37.25 28.63 1406 10.20 39.40 atdma* 1.1

e448.c7dd.f2c5 C1/0/U1 1 36.75 28.80 1406 10.20 39.40 atdma* 1.1

e448.c7dd.f2c5 C1/0/U2 1 38.50 30.79 1406 10.20 39.40 atdma* 1.1

I need to get this parameters by another monitoring system querying CMTS via SNMP (not by querying modems again). I found MIB CISCO-DOCS-REMOTE-QUERY-MIB but it looks that this MIB doesn't support DOCSIS v3.0 and channel bonding, because there are no parameters like USPwr or USMER for every upstream channel from bonding group. Via CMTS I can see these parameters:

Does any MIB exist for DOCSIS 3.0 remote query?

http://tools.cisco.com/ITDIT/MIBS/MainServlet?IMAGE_NAME=ubr7200p-jk9su2-mz.122-33.SCD6.bin

Thanks.

arni.s.eggertsson · ‎04-11-2012

Hi,

Did you have any luck locating MIBs for doing remote query on DOCSIS 3.0 information ?

best regards,

Arni Snorri Eggertsson

Miroslav Habanik · ‎04-11-2012

Hi,

no I have not been successful. Perhaps there is no such MIB.

cablefuzzy · ‎04-13-2012

Hi,

>Perhaps there is no such MIB.

not impossible, but unbelievable.

I have the same problem and triggered my Cisco support persons to investigate the problem.

As soon as I know more, I'll post here.

What I found out until today is: With SCF1 it is not possible to read out the two IF3-MIB Tables

docsIf3CmStatusUsTable and docsIf3CmStatusTable.

There must be an equivalent to the CISCO-DOCS-REMOTE-QUERY-MIB!

Best regards,

cablefuzzy