ā12-22-2011 11:23 AM - edited ā03-07-2019 04:01 AM
Dear Friends,
I have cisco 2960 switch, i erased the flash c2960-lanbasek9-mz.150-1.SE.bin and i updated c2960-lanbasek9-mz.150-1.SE.tar
via tftp server and every thing was done sucessfully, when i reload the switch in hypertrm is showing switch: there i could not do any thing and the next
i restarted the switch from that time i am not able to login hypertrm... in front panel syst led keep on blinking and even thernet port also showing down.
plz help me out....
Thanks
Srinivas.
ā12-22-2011 12:31 PM
ā12-22-2011 12:43 PM
Hi leolaohoo,
even i am not able to go rom monitor mode....
i am stucked at switch: promt only...
plz help me how to go rom monitor......
Thanks
Srinivas.
ā12-22-2011 01:09 PM
Have you tried "flash_init"?
ā12-22-2011 01:09 PM
Srini,
When at switch: prompt, you need to do the flash initialization and load_helper to start the xmodem recovery.
Please follow the link below and it should help.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
Cheers,
-amit singh
ā12-22-2011 01:35 PM
Hi Friends...
now could upload the ios through console..........
Thank you so much,
Srinivas.
ā12-22-2011 09:59 PM
Yes you can. My first post has a link to teach you how to load the IOS via console cable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide