ā12-22-2011 11:23 AM - edited ā03-07-2019 04:01 AM
Dear Friends,
I have cisco 2960 switch, i erased the flash c2960-lanbasek9-mz.150-1.SE.bin and i updated c2960-lanbasek9-mz.150-1.SE.tar
via tftp server and every thing was done sucessfully, when i reload the switch in hypertrm is showing switch: there i could not do any thing and the next
i restarted the switch from that time i am not able to login hypertrm... in front panel syst led keep on blinking and even thernet port also showing down.
plz help me out....
Thanks
Srinivas.
ā12-22-2011 12:31 PM
ā12-22-2011 12:43 PM
Hi leolaohoo,
even i am not able to go rom monitor mode....
i am stucked at switch: promt only...
plz help me how to go rom monitor......
Thanks
Srinivas.
ā12-22-2011 01:09 PM
Have you tried "flash_init"?
ā12-22-2011 01:09 PM
Srini,
When at switch: prompt, you need to do the flash initialization and load_helper to start the xmodem recovery.
Please follow the link below and it should help.
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
Cheers,
-amit singh
ā12-22-2011 01:35 PM
Hi Friends...
now could upload the ios through console..........
Thank you so much,
Srinivas.
ā12-22-2011 09:59 PM
Yes you can. My first post has a link to teach you how to load the IOS via console cable.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: