Check IOS version on a standby Sup on Cat6500

Unanswered Question
Jan 12th, 2012
User Badges:

Hi,

I wonder whethere it is possible to check the the IOS version on the standby sup720 of a 6500? if yes, what command would you use?

thanks,

han

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rsimoni Thu, 01/12/2012 - 11:47
User Badges:
  • Cisco Employee,

you can check with

show redundancy

or

remote command standy-rp show version


Riccardo


don't forget to rate and close question if helpful

Reza Sharifi Thu, 01/12/2012 - 11:49
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Hi,


If SSO is configured correctly then try "sh redu"

This command will tell you the IOS on the active and stand-by sup


HTH

hanwucisco Thu, 01/12/2012 - 12:35
User Badges:

Reza,

I was troubleshooting an error. It says redundancy mismatches. When I used the command you recommanded, i could not find anything that showed mismtach. any idea?



Please look at the results from the attached file.


thanks,

Han





Reza Sharifi Thu, 01/12/2012 - 13:22
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Han,


Your Sups are in SSO mode.  The primary is active and the stand-by is Hot.  You are also running the save version of IOS on both sups.  Everything looks good.  I am not sure why you had that error.


HTH

rsimoni Fri, 01/13/2012 - 01:44
User Badges:
  • Cisco Employee,

why don't you print the message you got? you are way too vague

Actions

This Discussion