×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Help! CME config with Viking Icom

Unanswered Question
Jan 13th, 2012
User Badges:

To preface, I am a total novice with CME.   Now that that is out of the way....I have a Viking single push button intercom and Viking remote touch tone relay controller that I need to somehow interface with our CME.  Functionally, the way this should work is when a user pushes the call button on the intercom box, it auto dials the receptionist's phone.  The relay will connect to an FXS port on our CME, but I have no idea how to configure the dial-peer for this to work.  Any suggestions will be greatly appreciated. 

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
michaelriginio Fri, 01/13/2012 - 09:39
User Badges:

Never mind. I figured it out.  For those who might need help in the future, the commands are below.


Voice-port 0/3/0  <

  connection plar XXXX   <

  station-id name VIKING  <

Actions

This Discussion