×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ATA187 and CCM4.1

Unanswered Question
Jan 16th, 2012
User Badges:

Hi Expert,


I need to order ATA 186 but this model already end so i have to order ATA 187 instead. Anyway, i use CCM version 4.1(3) so can i register ATA to CCM? Pls let me know if upgrade CCM to new version (I think version 8) is only way for solution. Thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jonathan Schulenberg Mon, 01/16/2012 - 03:23
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

You must upgrade to CUCM 7.1(5) or later for the ATA187 to work. The short answer is that it uses SIP which CCM 4.1 had no support of on the line-side of the system.

acampbell Mon, 01/16/2012 - 03:27
User Badges:
  • Green, 3000 points or more

Hi,


According to the SW download page


You can run an187 on CUCM 6.1.5 +


You need to load

cmterm-ata187-qed.9-2-3-1.cop.sgn first to allow the device type part

of the CUCM device lists on the PUB only

See readme

http://www.cisco.com/web/software/282074215/64021/cmterm-ata187-9-2-3-1-readme.html



Then you load cmterm-ata187.9-2-3-1.cop.sgn

For upgrading and usage on all servers


So 4.1 to 6.1.5 should allow you to proceed


Regards

Alex

Actions

This Discussion